Rubber Recess Former

  • Ancotec Rubber Recess Former create accurate recesses to accommodate the Lifting Clutches during the casting process.
  • Ancotec Rubber Recess Former is produced from customized rubber formulation using pure material which allow optimum performance during application.
  • Dimensions of each Recess Formers are engineered unique to the corresponding lifting clutches load classifications to minimize risks of errors.

Installation

The recess plug is spread open and set over the anchor head and is then attached to the mould using the stamped metal plate with the fixing bolt and wing nut. On tightening the wing nut, the recess plug is pressed against the mould and clamped around the anchor head at the same time.

Removal

To extract the plug from the set concrete, reinforcement bars are to be inserted into the two openings provided. The plug is then levered out of the mould.

Disclaimer: The construction applications and details provided in this website are indicative only. In every case, project working details should be entrusted to appropriately qualified and experienced personnel.
Whilst every care has been exercised in the preparation of this catalogue to ensure that any advice, recommendations or information is accurate, no liability or responsibility of any kind is accepted in respect of Ancotec Sdn Bhd. 
With a policy of continuous product development, Ancotec Sdn Bhd reserves the right to modify design and specification without prior notice.

Copyright 2024 Ancotec Sdn Bhd

Designed by Dev-Its